FloPlast Solvent Weld Waste Reducer - 50mm x 32mm Anthracite Grey
This waste reducer is used when a 32mm waste pipe is connected into a 40mm pipe, usually with the 32mm pipe dropping into the 40mm pipe below it running towards the soil pipe.
It is usually used in the branch of a 40mm tee or in one end of a 40mm coupling.
Our solvent weld waste is manufactured in the UK to BS EN 1455 and is kitemarked.
To make a solvent weld joint, first, ensure that the outer wall of the pipe and the inner wall of the fitting are both clean and free from grit or swarf. Apply SC250 solvent cement to both surfaces. Push the pipe fully into the fitting and give it a twist to ensure that full contact has been made. Clean off any excess solvent with a damp cloth and leave for 5 minutes to set. The installation should be left for 12 hours before testing.
Click here to watch a step by step video of how to make a solvent weld joint.
Solvent weld joints are permanent - they cannot be demounted once the joint has been made. When using solvent cement, always work in a well-ventilated area and keep the cement away from heat sources or naked flames. Avoid any contact with skin - if contact does occur then wash thoroughly with soap and water.
Solvent Weld Waste System
Solvent weld waste pipe and fittings have been used by professionals and homeowners for many years. When solvent cement is applied to the walls of the pipe and the fitting, it temporarily breaks down the surface wall of the ABS plastic. When the pipe is inserted into the fitting at this point, the two surfaces are quickly welded together and solidified to form a permanent watertight joint.
Our solvent weld pipes and fittings are supplied by FloPlast, one of the UK market leaders in the manufacture and supply of above and below ground drainage products.
Our ABS solvent weld waste systems are available in white, black, grey and anthracite grey.