Xtraflo Guttering Installation (Video)

This video provided by our Gutter Manufacturers FloPlast explains in detail how to install PVC Gutters. The sequence and process is the same regardless of the shape and size of the PVC Gutter system, although you should bear in mind that XtraFlo fascia brackets should be spaced at 600mm centres. This system also utilises 110mm downpipe as opposed to the standard 68mm, but whilst the size is different the installation process is the same.

First, fit the gutter end bracket just below the top of the fascia using 225mm by 5mm round head brass or zinc screws.
Position the gutter outlet where the downpipe will be located, ensuring it’s lower than the end bracket.
Attach a piece of string between the outlet and the end bracket as a position guide for the other support brackets.
Using a spirit level, ensure that there is a fall towards the outlet to allow the water to fall to the desired side.
Using two 25mm by 5mm round head brass or zinc screws, attach the supporting fascia brackets evenly between the end bracket and the position of the gutter outlet or union piece, if used for longer spans.
Ensure brackets are positioned at a maximum of 600 mm apart.
Fit the first piece of guttering using the front to back rule.
If required, fit a stop end supported by a bracket within 150mm of the stop end.
For additional lengths of guttering, fit a union bracket and use a silicon lubricant for easy fitting.
Ensure all pipework is cut and fitted to the indicated expansion line.
To fit the downpipe, drop a plumb line from the outlet to correctly align the downpipe clips.
Fit the uppermost lengths of the downpipe first, securing brackets with two 32mm by 6.5 round head brass or zinc screws.
If angles, unions or offset bends are used, then secure the brackets within 150mm of the fitting.
For additional pieces of downpipe, use a socket and pipe clip.
Finally, fit a shoe at the end of the downpipe.
To stop the build-up of leaves, fit gutter and outlet guards.